J. Drasner & Co., Inc. Products
Home | Film Products | Chemical Additives | Case Studies | FAQ | About Bags | Contact Us

LM-1

Ethylene Copolymer Film

The LM-1 line of plastic film and bags are derived from a family of ethylene copolymers made using the Metallocene or Single Site catalyst technology. These films melt between 73°C and 75°C. LM-1 bags are suitable for packaging blended and pre-weighed additives used in mixing rubber compounds.

The LM-1 film and bags are being used in a wide variety of rubbermaterials and exhibit excellent dispersability and compatibility. They have demonstrated excellent chemical resistance and have a low water vapor transmission rate for packaging moisture sensitive materials.

LM-1 film and bags can be heat sealed and printed. They are well suited for use with form, fill, and seal machines and produce strong heat seals even through dust and powders. Testing should be done to determine optimum sealing temperatures. Bags are available as individual lay flats or on rolls. Custom sizes can be produced at the customer's request.


  
  Material Safety Data Sheet (78K PDF)*
  
Typical Film Properties
LM-1
Film Thickness 2.0 mils
Melting Point   73°-75°C
Density 0.88-0.89 g/cm3
Dart Impact    
Tensile MD
TD
4,100 psi
3,800 psi
1% Secant Modulus MD
TD
4,400 psi
4,600 psi
Puncture Resistance 40 ft.-lb./cu. in.
Elmendorf Tear MD
TD
45 g/mil
100 g/mil

* Download the Material Safety Data Sheets in PDF format. Viewing and printing them requires the free Adobe Reader program, which you might already have. If you don't have it, download the Adobe Reader for free.

J. Drasner & Co., Inc. J. Drasner & Co., Inc.
23600 Mercantile Rd., Unit I • Beachwood, OH  44122 • USA
Phone: (216) 765-8805 • Fax: (216) 765-8816
Email: bags@jdrasner.com
 
© J. Drasner & Co., Inc.
Powered By Dynamics Online, Inc.
Top